1 Body
1 Body
Made of canted and welded sheet steel, with continuous sealed edges on the door and flap opening. Opening with rails to hold the base plate in place in the base area, and with perforated depth profiles at the side for mounting support rails, system profiles and installed equipment as well as holes for securing the plinth and sides. Versions with doors at the back are also possible.
2 Base plates
2 Base plates
Divided base plate, can be variably adjusted and held in place using clamps. Single part versions with and without cable entry, flanges or hole patters also available.
3 Doors
3 Doors
One or two front doors made of sheet steel canted all round, that is welded at the corners. Foam seal all round. Version with one door up to a console width of 1000mm, with a locking and a swing door as from a width of 1000 mm. Hinges with 120° opening angle, reversible door swing. Two-door versions also available from a width of 800 mm, optionally also with 180° hinges, asymmetrically divided doors, removable doors, doors with windows, cut-outs and hole patterns.
4 Flap
4 Flap
Made of canted sheet steel all round, that is welded at the edges. Angle of inclination 20°. Foam seal all round. Can be lifted up and held in place at an opening angle of approx. 72°. With recessed grip inside and two concealed hinges or three hinges as from a width of 1050 mm. Horizontal mounting strip on the inside of the hinge side.
5 Locking system
5 Locking system
Two casement fasteners each on the door or lockable door and on the flap, with 3mm double bit insert. Can also be fitted with other operating mechanisms.
6 Mounting plate
6 Mounting plate
Made of galvanised sheet steel, mounted on the back. Height can be adjusted twice by 40 mm.